Technical Support Assistance

Linksys RE1000 setup-Quick Guide

Linksys RE1000 setup-Quick Guide
August 14, 2020 No Comments Linksys RE1000 setup-Quick Guide Salina Smith

In this article we’ll guide you for Linksys RE1000 SetupQuick Guide. Linksys RE1000 MU-MIMO range extender may be a range extender and a tri-band Ethernet bridge which will give your Wi-Fi a boost and abolish dead zone in hard reach areas like your garage, backyard or bedroom.

Once you setup RE1000, as compared to dual-band range extender you’ll find 3 times faster speed, all because of its 5 GHz dedicated backhaul connection.

With MI-MIMO technology, your Wi-Fi is sure to be delivered faster and with more efficient throughout for every MU-MIMO connected devices. Here, the RE1000 setup to consider:

Your RE1000 Setup has been successfully completed.

Just in case you are unable to setup and install your RE1000 MU-MIMO range extender, get in touch with our well-trained technicians.

Linksys RE1000 setup-Quick Guide
Linksys RE1000

Linksys RE1000 Troubleshooting

1. Linksys RE1000 MU-MIMO range extender, by default it is scans for a 5 GHz Wi-Fi to use it as a fanatical backhaul (uplink) connection to a dual band router. If your RE1000 is unable to ascertain the 5 GHz network, here are belongings you can check (in the following):

  • Does your existing wireless router support dual-band networks?

If the existing Wi-Fi only supports 2.4 Ghz connection, then select the “Choose 2.4 Ghz Wi-Fi band” option. Your extender will then scan for the 2.4GHz connection.

  • The RE1000 does not support dynamics frequency selection (DFS) channels. If your router supports DFS channels, then extender will not detect the 5GHz band because it is possible that your router is using a DFS channel. If the extender is too far away, try to move the extender closer for setup. After the Linksys RE1000 setup, you can move it to another location.

If you are still having the same issue, connect with our experts an resolve the issue in a matter of minutes.

2. Poor signal or slow speed on my Linksys RE1000M_MIMO range extender.

If you are having issue of slow speed or poor signal even after Linksys RE1000 setup?

Follow the steps outlined below and fix the issue:

Firstly make sure to locate your Linksys RE1000 in perfect location, as instructed by the spot Finder Technology.

Then choose the Wi-Fi stronger signal.

Confirm to keep the RE1000 extender aside from electronic devices and radioactive such as microwave ovens, Bluetooth devices, cordless phones, washing machines, treadmills, refrigerator, etc.

Also, locate your extender at a particular ways from reflexive surface like mirrors, glasses and fish tanks.

Here we completely solved the issue, you are good to go.

About The Author

Leave a reply

Your email address will not be published. Required fields are marked *